Arduino Tinkercad Coding

A) Connect a second LED to the Arduino via the  breadboard. Upload code that turns on both LED’s when you  press the button.

B) Using the same LED set up from  A), have one LED turn on when the button is pressed and the other LED turn on when the button isn’t being pressed.

C) Add a second button to the setup from Task B. Make an LED turn on if one button is pressed and the other LED turn on if the other button is pressed.

D) When you press a button once, it makes tne LED produce 3 half-second blinks. When you press a second button, it makes the same LED produce 3 quarter second blinks

E) Take the code and parts you used in task D and wire everything directly without a breadboard. But instead of the breadboard button, use the normal sized button shown below.